Your shopping cart is empty!
American Association of State and Highway Transportation Officials, 2006
Publisher: AASHTO
File Format: PDF
$20.00$40.00
Pages:7
File Size:1 file , 1.7 MB
Note:This product is unavailable in Ukraine, Russia, Belarus
This specification covers requirements for the flow table and accessory apparatus (see Note 1) used in making flow tests for consistency of mortars in tests of hydraulic cement.
Note 1—To help clarify the design of the flow table and accessory apparatus see the drawing in Figure 1 [Figure 2]. This drawing is for informational purposes only.
The values stated in either SI units or inch–pound units shall be regarded separately as standard. The values stated are not exact equivalents; therefore, each system must be used independently of the other. It is permissible to use an inch–pound caliper and mold with an SI flow table or an SI caliper and mold with an inch–pound flow table. It is not permissible to mix an SI mold with an inch–pound caliper or an inch–pound mold with an SI caliper.
Standard Method of Test for Determining the Influence of Road Surfaces on Vehicle Noise Using the Statistical Isolated Pass-By (SIP) Method
$53.00 $107.00
Standard Method of Test for Characterization of the Air-Void System of Freshly Mixed Concrete by the Sequential Pressure Method
$49.00 $99.00
Standard Method of Test for Polymer Content of Polymer-Modified Emulsified Asphalt Residue and Asphalt Binders
$43.00 $86.00
Standard Specification for Precast Reinforced Concrete Manhole Sections (ASTM Designation: C478M-15a and C478-15a)
$36.00 $73.00
