Your shopping cart is empty!
American Association of State and Highway Transportation Officials, 2014
Publisher: AASHTO
File Format: PDF
$26.00$52.00
Pages:5
File Size:1 file , 1.5 MB
Note:This product is unavailable in Ukraine, Russia, Belarus
This practice covers field sampling and fabrication and initial curing of 50-mm (2-in.) cube specimens of non-shrink grout or mortar materials, or both.
The values stated in either inch-pound or SI units shall be regarded separately as standard. The inch-pound units are shown in parentheses. The values stated might not be exact equivalents; therefore, each system must be used independently of the other.
Note—“Unit weight” was the previous terminology used to describe the property determined by this practice, which is mass per unit volume.
This standard was formerly designated as provisional standard TP 83.
Standard Recommended Practice for Sampling and Fabrication of 50-mm (2-in.) Cube Specimens Using Grout (Non-Shrink) or Mortar
$26.00 $52.00
Standard Specification for Preformed Expansion Joint Fillers for Concrete Paving and Structural Construction (Nonextruding and Resilient Bituminous Types) (ASTM Designation: D1751-18)
$32.00 $65.00
Standard Recommended Practice for Calibrating the Load Cell and Deflection Sensors for a Falling Weight Deflectometer
$44.00 $89.00
Standard Method of Test for Solubility of Bituminous Materials (ASTM Designation: D2042-01)
Standard Method of Test for Determining the Influence of Road Surfaces on Vehicle Noise Using the Statistical Isolated Pass-By (SIP) Method
$48.00 $97.00
