• Your shopping cart is empty!

  • AASHTO T 213M/T 213-11 (2019)

AASHTO T 213M/T 213-11 (2019)

Standard Method of Test for Mass [Weight] of Coating on Aluminum-Coated Iron or Steel Articles [ASTM Designation: A 428/A 428M-10]

American Association of State and Highway Transportation Officials, 2011

Publisher: AASHTO

File Format: PDF

$30.00$61.00


Pages:9

File Size:1 file , 1.1 MB

Note:This product is unavailable in Ukraine, Russia, Belarus

AASHTO T 213M/T 213-11 (2019) covers procedures for determining the mass [weight] of coating on aluminum-coated iron or steel sheets and wire, and on other aluminum-coated iron and steel articles.

For sheet products, the final results are expressed as either coating mass [weight] total both sides, or coating mass [weight] separately on each side, depending on the specified requirements.

Current regulation codes and hazard classifications for chemicals used in this test method are listed in R 16.

This test is identical to ASTM A 428/A 428 M-10 except for inch-pound units, rather than SI units, shown in brackets; the addition of Section 1.5; and the additional requirement at the end of Section 8.1.

More AASHTO standard pdf

AASHTO M 213-22

AASHTO M 213-22

Standard Specification for Preformed Expansion Joint Fillers for Concrete Paving and Structural Construction (Nonextruding and Resilient Bituminous Types) (ASTM Designation: D1751-18)

$32.00 $65.00

AASHTO R 32-20

AASHTO R 32-20

Standard Recommended Practice for Calibrating the Load Cell and Deflection Sensors for a Falling Weight Deflectometer

$44.00 $89.00

AASHTO T 44-22

AASHTO T 44-22

Standard Method of Test for Solubility of Bituminous Materials (ASTM Designation: D2042-01)

$32.00 $65.00

AASHTO T 389-20

AASHTO T 389-20

Standard Method of Test for Determining the Influence of Road Surfaces on Vehicle Noise Using the Statistical Isolated Pass-By (SIP) Method

$48.00 $97.00