• AASHTO TP 100-12 (2018)

AASHTO TP 100-12 (2018)

Standard Method of Test for Deep Foundation Elements under Bidirectional Static Axial Compressive Load

American Association of State and Highway Transportation Officials, 2012

Publisher: AASHTO

File Format: PDF

$44.00$89.00


Pages:15

File Size:1 file , 840 KB

Note:This product is unavailable in Ukraine, Russia, Belarus

This test method describes procedures for testing vertical or inclined deep foundation elements to determine their behavior characteristics in response to an internally applied axial static load. This method is applicable to all deep foundations that function in the same manner as bored piles regardless of their method of construction and installation.

Note - Bidirectional load testing has been successfully performed on driven piles. However, the installation and procedural differences associated with bidirectional load testing of driven piles are not covered in this standard.

This standard provides minimum requirements for bidirectional testing for deep foundation elements under controlled application of static axial compressive load. The engineer responsible for the foundation design shall approve any deviations, deletions, or additions to the requirements of this standard.

Note - Plans, specifications, or provisions, or some combination thereof, prepared by a qualified engineer may provide additional requirements and procedures as needed to satisfy the objectives of a particular test program.

Note - To determine the long-term performance of the foundation, the duration of each load step application may be extended and the test results may need additional interpretation.

A qualified engineer shall design and approve all loading apparatus, loaded members, and test procedures. The method used to specify how data is collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How the results obtained using this standard are applied is beyond the scope of this test standard.

More AASHTO standard pdf

AASHTO M 292M/M 292-22

AASHTO M 292M/M 292-22

Standard Specification for Carbon Steel, Alloy Steel, and Stainless Steel Nuts for Bolts for High-Pressure or High-Temperature Service, or Both (ASTM Designation: A194/A194M-20a)

$40.00 $81.00

AASHTO M 251M/M 251-22

AASHTO M 251M/M 251-22

Standard Specification for Plain and Laminated Elastomeric Bridge Bearings

$52.00 $105.00

AASHTO T 247-22

AASHTO T 247-22

Standard Method of Test for Preparation of Test Specimens of Hot Mix Asphalt (HMA) by Means of California Kneading Compactor (ASTM Designation: D1561-92)

$29.00 $59.00

AASHTO T 113-22

AASHTO T 113-22

Standard Method of Test for Lightweight Particles in Aggregate (ASTM Designation: C123/C123M-12)

$32.00 $65.00