• Your shopping cart is empty!

PDF Preview

AS 2718.1-1984

Plastics pipes and fittings for gas reticulation - Polyethylene - Outside diameter series, Part 1: Pipes

Standards Australia, 12/31/1983

Publisher: AS

File Format: PDF

$26.00$53.69


Published:31/12/1983

File Size:1 file , 1.5 MB

Note:This product is unavailable in Russia, Belarus

This Standard is based on ISO 4437 and specifies dimensions and general requirements for two classes of pipe for use in gas mains and services for direct burial and reliner applications, for the distribution of natural gas at pressures up to 400 kPa and of LP gas and mixtures of LP gas and air where the partial pressure of the LP gas component does not exceed 200 kPa. ISO 161-1 outside diameter series of tensions are used with a size range of 50 to 220.

AS 2718.1-1984 history

AS 2718.1-1984

AS 2718.1-1984

Plastics pipes and fittings for gas reticulation - Polyethylene - Outside diameter series, Part 1: Pipes

$26.00 $53.69

More AS standard pdf

IEC 60605-3-3 Ed. 1.0 b:1992

IEC 60605-3-3 Ed. 1.0 b:1992

Equipment reliability testing - Part 3: Preferred test conditions - Section 3: Test Cycle 3: Equipment for stationary use in partially weatherprotected locations - Low degree of simulation

$33.00 $66.00

IEC 60704-2-7 Ed. 1.0 b:1997

IEC 60704-2-7 Ed. 1.0 b:1997

Household and similar electrical appliances - Test code for the determination of airborne acoustical noise - Part 2-7: Particular requirements for fans

$23.00 $47.00

IEC 61158-2 Ed. 5.0 en:2010

IEC 61158-2 Ed. 5.0 en:2010

Industrial communication networks - Fieldbus specifications - Part 2: Physical layer specification and service definition

$178.00 $356.00

IEC 60814 Ed. 2.0 b:1997

IEC 60814 Ed. 2.0 b:1997

Insulating liquids - Oil-impregnated paper and pressboard - Determination of water by automatic coulometric Karl Fischer titration

$95.00 $190.00