Your shopping cart is empty!
ASTM International, 04/01/2013
Publisher: ASTM
File Format: PDF
$33.00$67.00
Published:01/04/2013
Pages:11
File Size:1 file , 150 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers a group of requirements that, unless otherwise specified in an individual specification, shall apply to the ASTM product specifications noted below.
Title of Specification
ASTM DesignationA
Seamless Carbon-Molybdenum Alloy-Steel Boiler and Superheater Tubes
A209/A209M
Seamless Ferritic and Austenitic Alloy-Steel Boiler, Superheater, and Heat-Exchanger Tubes
A213/A213M
Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger, and Condenser Tubes
A249/A249M
Electric-Resistance-Welded Ferritic Alloy-Steel Boiler and Superheater Tubes
A250/A250M
Seamless and Welded Ferritic and Martensitic Stainless Steel Tubing for General Service
A268/A268M
Seamless and Welded Austenitic Stainless Steel Tubing for General Service
A269
Seamless and Welded Austenitic Stainless Steel Sanitary Tubing
A270
Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature Service
A334/A334M
Welded Austenitic Stainless Steel Feedwater Heater Tubes
A668/A668M
Austenitic Stainless Steel Tubing for Breeder Reactor Core Components
A771/A771M
Seamless and Welded Ferritic/Austenitic Stainless Steel Tubing for General Service
A789/A789M
Welded Ferritic Stainless Steel Feedwater Heater Tubes
A803/A803M
Austenitic and Ferritic Stainless Steel Duct Tubes for Breeder Reactor Core Components
A826/A826M
High-Frequency Induction Welded, Unannealed Austenitic Steel Condenser Tubes
A851
1.2 In the case of conflict between a requirement of a product specification and a requirement of this general requirements specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this general requirements specification and a more stringent requirement of the purchase order, the purchase order shall prevail.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation (SI) of the product specification is specified in the order.
Standard Specification for Design and Performance of an Airborne Sense-and-Avoid System (Withdrawn 2014)
$25.00 $50.00
Standard Test Method for Evaluation of Automotive Engine Oils in the Sequence IIIF, Spark-Ignition Engine
$45.00 $91.00
Standard Practice for Evaluating Absorptive Solar Receiver Materials When Exposed to Conditions Simulating Stagnation in Solar Collectors With Cover Plates
$26.00 $52.00
Standard Test Method for Freeze-Thaw Stability of Multicolor Lacquers
