Your shopping cart is empty!
ASTM International, 03/15/2017
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:15/03/2017
Pages:12
File Size:1 file , 150 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers a group of requirements that, unless otherwise specified in an individual specification, shall apply to the ASTM product specifications noted below.
Title of Specification
ASTM DesignationA
Seamless Carbon-Molybdenum Alloy-Steel Boiler and Superheater Tubes
A209/A209M
Seamless Ferritic and Austenitic Alloy-Steel Boiler, Superheater, and Heat-Exchanger Tubes
A213/A213M
Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger, and Condenser Tubes
A249/A249M
Electric-Resistance-Welded Ferritic Alloy-Steel Boiler and Superheater Tubes
A250/A250M
Seamless and Welded Ferritic and Martensitic Stainless Steel Tubing for General Service
A268/A268M
Seamless and Welded Austenitic Stainless Steel Tubing for General Service
A269/A269M
Seamless and Welded Austenitic Stainless Steel Sanitary Tubing
A270/A270M
Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature Service
A334/A334M
Welded Austenitic Stainless Steel Feedwater Heater Tubes
A688/A688M
Austenitic Stainless Steel Tubing for Breeder Reactor Core Components
A771/A771M
Seamless and Welded Ferritic/Austenitic Stainless Steel Tubing for General Service
A789/A789M
Welded Ferritic Stainless Steel Feedwater Heater Tubes
A803/A803M
Austenitic and Ferritic Stainless Steel Duct Tubes for Breeder Reactor Core Components
A826/A826M
High-Frequency Induction Welded, Unannealed Austenitic Steel Condenser Tubes
A851
1.2 In the case of conflict between a requirement of a product specification and a requirement of this general requirements specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this general requirements specification and a more stringent requirement of the purchase order, the purchase order shall prevail.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation (SI) of the product specification is specified in the order.
Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing
$33.00 $67.00
Standard Practice for Independent Audit Program for Light Aircraft Manufacturers
$25.00 $50.00
Standard Practice for Rubber - ;Calculation of Producer's Process Performance Indexes
$26.00 $52.00
Standard Practice for Vapor Attack on Refractories for Furnace Superstructures
