Your shopping cart is empty!
ASTM International, 07/01/2020
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:01/07/2020
Pages:10
File Size:1 file , 170 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers commercial, structural, high-strength low-alloy, and ultra-high strength steel sheet in coils and cut lengths produced by the twin-roll casting process.
1.2 The steel sheet is available in the designations listed in Section 4.
1.3 The material is available in the following sizes:
Thickness:
0.027 to 0.078 in. [0.7 to 2.0 mm]
Width:
up to 79 in. [2000 mm]
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Note 1: A description of the Twin-roll Casting Process is included in Appendix X1.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Location of Wet Insulation in Roofing Systems Using Infrared Imaging
$24.00 $48.00
Standard Specification for Deformed and Plain Stainless Steel Wire and Welded Wire for Concrete Reinforcement
$32.00 $64.00
Standard Test Methods for Measurement of Hydraulic Conductivity of Unsaturated Soils
$34.00 $69.00
Standard Practice for Accelerated Aging of Asphalt Binder Using a Pressurized Aging Vessel (PAV)
$34.00 $68.00
