1.1 This specification covers laser-fused stainless steel bars, plates, and shapes of structural quality for use in bolted or welded structural applications.
1.2 Shapes covered in this specification include those classified in Article 3.1.2 of Specification A6/A6M and those that are made from two or more shapes or plates.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
More ASTM standard pdf
ASTM F2494-05(2011)
Standard Test Method for Determining Energy Consumption of Copiers and Similar Office Imaging Equipment (Withdrawn 2020)
$30.00 $60.00
ASTM D2809-04e2
Standard Test Method for Cavitation Corrosion and Erosion-Corrosion Characteristics of Aluminum Pumps With Engine Coolants
$30.00 $60.00
ASTM E637-05(2011)
Standard Test Method for Calculation of Stagnation Enthalpy from Heat Transfer Theory and Experimental Measurements of Stagnation-Point Heat Transfer and Pressure
$33.00 $67.00