Your shopping cart is empty!
ASTM International, 12/15/2013
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:15/12/2013
Pages:3
File Size:1 file , 170 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice defines procedures for measuring the width of steel sheet when decimal, not fraction tolerances are indicated. The ability to accurately measure width using hand calipers is critical in determining if product meets decimal specifications. The methods described are designed and intended for use in the laboratory, mill situations, and general use.
1.2 The flat steel product shall conform to all the requirements of the appropriate specifications as follows: Specifications A917 and A924/A924M.
1.3 Quantitative limits are not addressed and are established in the general requirements, or individual product specifications, or both; or when applicable, as agreed to between supplier and user.
1.4 This specification is applicable to orders in either inch-pound units or SI units. Values in inch-pound and SI units are not necessarily equivalent. Within the text, SI units are shown in brackets. Each system shall be used independently of the other.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Measurement of Heat of Hydration of Hydraulic Cementitious Materials Using Isothermal Conduction Calorimetry
$29.00 $58.00
Standard Test Methods for Determining Dispersive Characteristics of Clayey Soils by the Crumb Test
$30.00 $60.00
Standard Test Methods for Determining Mechanical Integrity of Photovoltaic Modules
$26.00 $52.00
Standard Practice for Decontamination of Field Equipment Used at Waste Sites