• ASTM A27/A27M-13

ASTM A27/A27M-13

Standard Specification for Steel Castings, Carbon, for General Application

ASTM International, 11/01/2013

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/11/2013

Pages:4

File Size:1 file , 76 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers carbon steel castings for general applications that require up to 70 ksi (485 MPa) minimum tensile strength.

Note 1-The grades covered by this specification represent materials that are suitable for assembly with other steel castings or wrought steel parts by fusion welding. It is not intended to imply that all these grades possess the same degree of weldability or that the same welding techniques can be used on all castings. It is the responsibility of the purchaser to establish for himself a suitable welding technique.

1.2 Several grades and two classes of steel castings are covered, as indicated below. The grade and class desired shall be specified by the purchaser.

1.2.1 Grade N-1-Chemical analysis only.

1.2.2 Grade N-2-Heat-treated but not mechanically tested.

1.2.3 Grade U-60-30 [415-205]-Mechanically tested but not heat-treated.

1.2.4 Grades 60-30  [415-205], 65-35 [450-240], 70-36 [485-250], and 70-40 [485-275]-Heat-treated and mechanically tested.

1.2.5 Class 1 and Class 2 steel castings shall be specified in accordance with 9.2.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D2846/D2846M-99

ASTM D2846/D2846M-99

Standard Specification for Chlorinated Poly(Vinyl Chloride) (CPVC) Plastic Hot- and Cold-Water Distribution Systems

$33.00 $67.00

ASTM F2750-16

ASTM F2750-16

Standard Test Method for Determining the Effects of Bending a Membrane Switch or Printed Electronic Device

$21.00 $42.00

ASTM D2163-14e1

ASTM D2163-14e1

Standard Test Method for Determination of Hydrocarbons in Liquefied Petroleum (LP) Gases and Propane/Propene Mixtures by Gas Chromatography

$34.00 $69.00

ASTM C828-11

ASTM C828-11

Standard Test Method for Low-Pressure Air Test of Vitrified Clay Pipe Lines

$26.00 $52.00