Your shopping cart is empty!
ASTM International, 06/01/2015
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:01/06/2015
Pages:4
File Size:1 file , 71 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers normalized and tempered, and quenched and tempered, carbon and alloy steel forged or rolled rings for reduction gears.
1.2 Several grades and classes of steel are covered as follows:
1.2.1 Grade 1, Classes A and B, and Grade 2, Classes C and D, are carbon steel.
1.2.2 Grade 3, Classes E and F, Grade 4, Classes G, H, I, J, K and L, Grade 5, Classes M and P, and Grade 6, Class T, are alloy steel.
1.2.3 All grades and classes are considered weldable under proper conditions. Welding techniques are of fundamental importance and it is pre-supposed that welding procedure and inspection will be in accordance with proper methods for the class of material used.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Guide for Measurement of Behavior During Fish Toxicity Tests
$32.00 $65.00
Standard Specification for Cartridge Brass Cartridge Case Cups
$29.00 $58.00
Standard Terminology Relating to Dimension Stone
$30.00 $60.00
Standard Terminology Relating to Hemostatic Forceps
$25.00 $50.00
