Your shopping cart is empty!
ASTM International, 05/01/2012
Publisher: ASTM
File Format: PDF
$33.00$67.00
Published:01/05/2012
Pages:16
File Size:1 file , 150 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification2 covers a group of common requirements which, unless otherwise specified in the purchase order or in an individual specification, shall apply to carbon and alloy steel bars under each of the following ASTM specifications (or under any other ASTM specification which invokes this specification or portions thereof):
Title of Specification
ASTM DesignationA
Hot-Rolled Carbon Steel Bars:
Steel Bars, Carbon, Quenched and Tempered
A321
Steel Bars and Shapes, Carbon Rolled from “T'' Rails
A499
Steel Bars, Carbon, Merchant Quality, M-Grades
A575
Steel Bars, Carbon, Hot-Wrought, Special Quality
A576
Steel Bars, Carbon, Merchant Quality, Mechanical Properties
A663/A663M
Steel Bars, Carbon, Hot-Wrought, Special Quality, Mechanical Properties
A675/A675M
Steel Bars for Springs, Carbon and Alloy
A689
Cold-Finished Carbon Steel Bars:
Steel Bars, Carbon and Alloy, Cold-Finished
A108
Cold-Drawn Stress-Relieved Carbon Steel Bars Subject to Mechanical Property Requirements
A311/A311M
Hot-Rolled Alloy Steel Bars:
Steel Bars, Alloy, Standard Grades
A322
Carbon and Alloy Steel Bars Subject to End-Quench Hardenability Requirements
A304
Steel Bars, Alloy, Hot-Wrought or Cold-Finished, Quenched and Tempered
A434
Steel Bars, Alloy, Hot-Wrought, for Elevated Temperature or Pressure-Containing Parts, or Both
A739
Cold-Finished Alloy Steel Bars:
Steel Bars, Alloy, Hot-Rolled or Cold-Finished, Quenched and Tempered
Steel Bars, Carbon, Hot-Wrought or Cold-Finished, Special Quality, for Pressure Piping Components
A696
1.2 In case of any conflict in requirements, the requirements of the purchase order, the individual material specification, and this general specification shall prevail in the sequence named.
1.3 The values stated in inch-pound units or SI units are to be regarded as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.4 For purposes of determining conformance to this specification and the various material specifications referenced in 1.1, dimensional values shall be rounded to the nearest unit in the right-hand place of figures used in expressing the limiting values in accordance with the rounding method of Practice E29.
Standard Test Method for Pour Point of Petroleum Products (Rotational Method)
$25.00 $50.00
Standard Practice for Specimens and Testing Conditions for Testing Polyethylene (PE) Pipe Butt Fusions Using Tensile and Hydrostatic Test Methods
$28.00 $57.00
Standard Terminology Relating to Roofing and Waterproofing
$29.00 $58.00
Standard Specification for Polyetheretherketone (PEEK) Polymers for Surgical Implant Applications
$34.00 $68.00