Your shopping cart is empty!
ASTM International, 09/01/2012
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/09/2012
Pages:6
File Size:1 file , 97 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the determination of the weight and composition of coating on terne sheet by the triple-spot method. The following three procedures are described:
1.1.1 Procedure A - Stripping with sulfuric acid.
1.1.2 Procedure D - Stripping with hydrochloric acid and antimony trichloride.
1.1.3 Procedure E - Stripping with hydrobromic acid-bromine solution.
1.2 If the percent of tin in the coating is required, stripping with hydrobromic acid-bromine is the preferred procedure. Steel with a predeposited electrolytic nickel coating requires a two-stage stripping method to determine total tin content. If both the tin and lead percentage are required, stripping with sulfuric acid is recommended, but caution is advised since the sulfuric acid procedure has been found to produce high tin results (see Section 11).
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Section 5, Note 2, and Section 17.
Standard Guide for Training and Qualification of Safety-Critical Space Operations Personnel
$27.00 $54.00
Standard Consumer Safety Specification for Toddler Beds
$36.00 $72.00
Standard Terminology for Nondestructive Examinations
$46.00 $92.00
Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt Binder (Rolling Thin-Film Oven Test)
$28.00 $57.00