Your shopping cart is empty!
ASTM International, 03/01/2004
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/03/2004
Pages:6
File Size:1 file , 77 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers several grades of minimum-wall-thickness, seamless and welded, carbon and alloy-steel tubes intended for use at low temperatures. Some product sizes may not be available under this specification because heavier wall thicknesses have an adverse affect on low-temperature impact properties.
1.2 Supplementary Requirement S1 of an optional nature is provided. This shall apply only when specified by the purchaser. For tubing smaller than Equation 1 - 1/2 in. [12.7 mm] in outside diameter, the elongation values given for strip specimens in shall apply. Mechanical property requirements do not apply to tubing smaller than Equation 2 - 1/8 in. [3.2 mm] in outside diameter and with a wall thickness under 0.015 in. [0.4 mm].
1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation of this specification is specified in the order.
Standard Test Method for Shear Strength (Dynamic Method) of Hook and Loop Touch Fasteners
$26.00 $52.00
Standard Specification for High Purity Titanium Sputtering Targets for Electronic Thin Film Applications
$21.00 $42.00
Standard Test Method for Determination of Boiling Range Distribution of Distillates and Lubricating Base Oils-in Boiling Range from 100 oC to 735 oC by Gas Chromatography
$28.00 $56.00
Standard Test Method for Electrical Conductivity and Resistivity of a Flowing High Purity Water Sample
$30.00 $60.00