• Your shopping cart is empty!

  • ASTM A335/A335M-15

ASTM A335/A335M-15

Standard Specification for Seamless Ferritic Alloy-Steel Pipe for High-Temperature Service

ASTM International, 05/01/2015

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/05/2015

Pages:10

File Size:1 file , 120 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification2 covers nominal wall and minimum wall seamless ferritic alloy-steel pipe intended for high-temperature service. Pipe ordered to this specification shall be suitable for bending, flanging (vanstoning), and similar forming operations, and for fusion welding. Selection will depend upon design, service conditions, mechanical properties, and high-temperature characteristics.

1.2 Several grades of ferritic steels (see Note 1) are covered. Their compositions are given in Table 1.

Note 1: Ferritic steels in this specification are defined as low- and intermediate-alloy steels containing up to and including 10 % chromium.

(A) New designation established in accordance with Practice E527 and SAE J1086, Practice for Numbering Metals and Alloys (UNS).
(B) Grade P 5c shall have a titanium content of not less than 4 times the carbon content and not more than 0.70 %; or a columbium content of 8 to 10 times the carbon content.
(C) Alternatively, in lieu of this ratio minimum, the material shall have a minimum hardness of 275 HV in the hardened condition, defined as after austenitizing and cooling to room temperature but prior to tempering. Hardness testing shall be performed at mid-thickness of the product. Hardness test frequency shall be two samples of product per heat treatment lot and the hardness testing results shall be reported on the material test report.

1.3 Supplementary requirements (S1 to S7) of an optional nature are provided. These supplementary requirements call for additional tests to be made, and when desired, shall be so stated in the order together with the number of such tests required.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order.

Note 2: The dimensionless designator NPS (nominal pipe size) has been substituted in this standard for such traditional terms as “nominal diameter,” “size,” and “nominal size.”

More ASTM standard pdf

ASTM F1487-01

ASTM F1487-01

Standard Consumer Safety Performance Specification for Playground Equipment for Public Use

$39.00 $79.20

ASTM E1836/E1836M-09e1

ASTM E1836/E1836M-09e1

Standard Practice for Building Floor Area Measurements for Facility Management

$32.00 $65.00

ASTM D3025-07

ASTM D3025-07

Standard Practice for Standardizing Cotton Fiber Test Results by Use of Calibration Cotton Standards

$26.00 $52.00

ASTM F2800-11(2017)

ASTM F2800-11(2017)

Standard Specification for Recirculating Hood System for Cooking Appliances

$21.00 $42.00