• ASTM A352/A352M-06(2012)

ASTM A352/A352M-06(2012)

Standard Specification for Steel Castings, Ferritic and Martensitic, for Pressure-Containing Parts, Suitable for Low-Temperature Service

ASTM International, 03/01/2012

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/03/2012

Pages:5

File Size:1 file , 89 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers steel castings for valves, flanges, fittings, and other pressure-containing parts intended primarily for low-temperature service.

1.2 Several grades of ferritic steels and one grade of martensitic steel are covered. Selection of analysis will depend on design and service conditions (Note). The temperature shown is the lowest temperature at which the material ordinarily is required to meet the impact requirements of this specification (see Supplementary Requirement S22, Impact Test Temperatures). Users should note that hardenability of some of the grades mentioned may restrict the maximum size at which the required mechanical properties are obtainable (see Appendix X1).

Grade Usual Minimum Testing
Temperatures, °F [°C]
LCA 25 [-32]
LCB 50 [-46]
LCC 50 [-46]
LC1 75 [-59]
LC2 100 [-73]
LC2-1 100 [-73]
LC3 150 [-101]
LC4 175 [-115]
LC9 320 [-196]
CA6NM 100 [73]

Note 1 - This specification covers the low-temperature requirements particularly pertinent for ferritic and martensitic steels. Certain of the grades of austenitic steel castings furnished in accordance with Specification A351/A351M have been found suitable for low-temperature service down to 300°F [184°C] and others down to 425°F [254°C]. These grades may be used when impact tested in accordance with Specification A352/A352M with energy levels and temperatures of test mutually agreed upon between the purchaser and the manufacturer. As a guide to the selection of energy levels and testing temperatures, Appendix X1 should be consulted.

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. Inch-pound units are applicable for material ordered to Specification A352 and SI units for material ordered to Specification A352M.

More ASTM standard pdf

ASTM D4726-15

ASTM D4726-15

Standard Specification for Rigid Poly(Vinyl Chloride) (PVC) Exterior-Profile Extrusions Used for Assembled Windows and Doors

$32.00 $65.00

ASTM B784-01(2017)e1

ASTM B784-01(2017)e1

Standard Specification for Modified Concentric-Lay-Stranded Copper Conductors for Use in Insulated Electrical Cables

$24.00 $48.00

ASTM E1949-03(2014)e1

ASTM E1949-03(2014)e1

Standard Test Method for Ambient Temperature Fatigue Life of Metallic Bonded Resistance Strain Gages

$31.00 $62.00

ASTM D6719-07

ASTM D6719-07

Standard Guide for Standard Test Methods and Practices for Evaluating Pile Yarn Floor Covering

$26.00 $52.00