Your shopping cart is empty!
ASTM International, 12/01/2016
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/12/2016
Pages:5
File Size:1 file , 79 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification2 covers relatively thin-walled forgings (including gas bottles) for pressure vessel use. Three types of carbon steel and six types of alloy steel are included. Provision is made for integrally forging the ends of vessel bodies made from seamless pipe or tubing.
Note 1: When working to the chemical and tensile requirements of this specification, the influence of wall thickness and cooling rate will necessarily eliminate certain forging sizes in each class.
Note 2: Designations have been changed as follows:
Current
Formerly
Grade A
Type I
Grade B
Type II
Grade C
Type III
Grade D
Type IV
Grade E Class 55
Type V Grade 1 Class 55
Grade E Class 65
Type V Grade 1 Class 65
Grade E Class 70
Type V Grade 1 Class 70
Grade F Class 55
Type V Grade 2 Class 55
Grade F Class 65
Type V Grade 2 Class 65
Grade F Class 70
Type V Grade 2 Class 70
Grade G Class 55
Type V Grade 3 Class 55
Grade G Class 65
Type V Grade 3 Class 65
Grade G Class 70
Type V Grade 3 Class 70
Grade H Class 55
Type V Grade 4 Class 55
Grade H Class 65
Type V Grade 4 Class 65
Grade H Class 70
Type V Grade 4 Class 70
Grade J Class 55
Type V Grade 5 Class 55
Grade J Class 65
Type V Grade 5 Class 65
Grade J Class 70
Type V Grade 5 Class 70
Grade K
Type VI
Grade L
Type VII
Grade J Class 110
Type VIII
Grade M Class 85
Type IX Class A
Grade M Class 100
Type IX Class B
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 Unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units.
Standard Specification for Niobium-Hafnium Alloy Bar and Wire
$26.00 $52.00
Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus
$33.00 $67.00
Standard Test Method for Stereological Evaluation of Porous Coatings on Medical Implants
$29.00 $58.00
Standard Guide for Using Aqueous Foams to Control the Vapor Hazard from Immiscible Volatile Liquids
