Your shopping cart is empty!
ASTM International, 03/01/2020
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/03/2020
Pages:5
File Size:1 file , 87 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification2 covers relatively thin-walled forgings (including gas bottles) for pressure vessel use. Three types of carbon steel and six types of alloy steel are included. Provision is made for integrally forging the ends of vessel bodies made from seamless pipe or tubing.
Note 1: When working to the chemical and tensile requirements of this specification, the influence of wall thickness and cooling rate will necessarily eliminate certain forging sizes in each class.
Note 2: Designations have been changed as follows:
Current
Formerly
Grade A
Type I
Grade B
Type II
Grade C
Type III
Grade D
Type IV
Grade E Class 55
Type V Grade 1 Class 55
Grade E Class 65
Type V Grade 1 Class 65
Grade E Class 70
Type V Grade 1 Class 70
Grade F Class 55
Type V Grade 2 Class 55
Grade F Class 65
Type V Grade 2 Class 65
Grade F Class 70
Type V Grade 2 Class 70
Grade G Class 55
Type V Grade 3 Class 55
Grade G Class 65
Type V Grade 3 Class 65
Grade G Class 70
Type V Grade 3 Class 70
Grade H Class 55
Type V Grade 4 Class 55
Grade H Class 65
Type V Grade 4 Class 65
Grade H Class 70
Type V Grade 4 Class 70
Grade J Class 55
Type V Grade 5 Class 55
Grade J Class 65
Type V Grade 5 Class 65
Grade J Class 70
Type V Grade 5 Class 70
Grade K
Type VI
Grade L
Type VII
Grade J Class 110
Type VIII
Grade M Class 85
Type IX Class A
Grade M Class 100
Type IX Class B
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 Unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Applying Statistical Quality Assurance and Control Charting Techniques to Evaluate Analytical Measurement System Performance
$41.00 $83.00
Standard Specification for Carbon and Alloy Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both
$33.00 $67.00
Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength
$30.00 $60.00
Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
