• ASTM A403/A403M-01

ASTM A403/A403M-01

Standard Specification for Wrought Austenitic Stainless Steel Piping Fittings

ASTM International, 10/10/2001

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:10/10/2001

Pages:8

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers wrought stainless steel fittings for pressure piping applications.

1.2 Several grades of austenitic stainless steel alloys are included in this specification Grades are designated with a prefix, WP or CR, based on the applicable ANSI or MSS dimensional and rating standards, respectively.

1.3 For each of the WP stainless grades, several classes of fittings are covered, to indicate whether seamless or welded construction was utilized. Class designations are also utilized to indicate the nondestructive test method and extent of nondestructive examination (NDE). Table 1 is a general summary of the fitting classes applicable to all WP grades of stainless steel covered by this specification. There are no classes for the CR grades. Specific requirements are covered elsewhere.

1.4 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished to inch-pound units.

1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.6 This specification does not apply to cast steel fittings. Austenitic stainless steel castings are covered in Specifications A351/A351M, A743/A743M, and A744/A744M.

More ASTM standard pdf

ASTM F310-07(2012)

ASTM F310-07(2012)

Standard Practice for Sampling Cryogenic Aerospace Fluids

$26.00 $52.00

ASTM D5761-96(2012)

ASTM D5761-96(2012)

Standard Practice for Emulsification/Suspension of Multiphase Fluid Waste Materials

$26.00 $52.00

ASTM E2561-07a

ASTM E2561-07a

Standard Practice for the Installation of Inductive Loop Detectors

$32.00 $65.00

ASTM D7501-12a

ASTM D7501-12a

Standard Test Method for Determination of Fuel Filter Blocking Potential of Biodiesel (B100) Blend Stock by Cold Soak Filtration Test (CSFT)

$30.00 $60.00