• ASTM A416/A416M-17

ASTM A416/A416M-17

Standard Specification for Low-Relaxation, Seven-Wire Steel Strand for Prestressed Concrete

ASTM International, 05/01/2017

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/05/2017

Pages:5

File Size:1 file , 79 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers two grades of low-relaxation, seven-wire steel strand for use in prestressed concrete construction. Grade 250 [1725] and Grade 270 [1860] have minimum tensile strengths of 250 ksi [1725 MPa] and 270 ksi [1860 MPa], respectively, based on the nominal area of the strand.

1.2 A supplementary requirement (S1) is provided for use where bond strength testing of 0.600-in. [15.24-mm] diameter Grade 270 [1860] strand for applications in prestressed ground anchors is required by the purchaser. The supplementary requirement applies only when specified in the purchase order.

1.3 The text of this specification contains notes or footnotes, or both, that provide explanatory material. Such notes and footnotes do not contain any mandatory information.

1.4 This specification is applicable for orders in either inch-pound units (as Specification A416) or in SI units (as Specification A416M).

1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D7917-14

ASTM D7917-14

Standard Practice for Inductive Wear Debris Sensors in Gearbox and Drivetrain Applications

$32.00 $65.00

ASTM E2769-11

ASTM E2769-11

Standard Test Method for Elastic Modulus by Thermomechanical Analysis Using Three-Point Bending and Controlled Rate of Loading

$29.00 $58.00

ASTM E643-84(2000)

ASTM E643-84(2000)

Standard Test Method for Ball Punch Deformation of Metallic Sheet Material (Withdrawn 2009)

$26.00 $52.00

ASTM Volume 12.01:2011

ASTM Volume 12.01:2011

ASTM Book of Standards Volume 12.01: Nuclear Energy (I)

$141.00 $282.85