• ASTM A450/A450M-02

ASTM A450/A450M-02

Standard Specification for General Requirements for Carbon, Ferritic Alloy, and Austenitic Alloy Steel Tubes

ASTM International, 09/10/2002

Publisher: ASTM

File Format: PDF

$31.00$62.00


Published:10/09/2002

Pages:10

File Size:1 file , 80 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers a group of requirements which, with the exceptions of 4.3 and Sections 5, 6, 17, 18, 19, 20, 21, 22, and 23, are mandatory requirements to the following ASTM tubular product specifications:

These designations refer to the latest issue of the respective specifications.
Title of Specification ASTM Designation
Electric-Resistance-Welded Carbon Steel and Carbon Manganese Steel Boiler Tubes A 178/A 178M
Seamless Cold-Drawn Low-Carbon Steel Heat-Exchanger and Condenser Tubes A 179/A 179M
Seamless Carbon Steel Boiler Tubes for High-Pressure Service A 192/A 192M
Seamless Medium-Carbon Steel Boiler and Superheater Tubes A 210/A 210M
Electric-Resistance-Welded Carbon Steel Heat-Exchanger and Condenser Tubes A 214/A 214M
Seamless and Electric-Welded Low-Alloy Steel Tubes A 423/A 423M
Electric-Resistance-Welded Coiled Steel Tubing for Gasand Fuel Oil Lines A 539
Seamless Cold-Drawn Carbon Steel Feedwater Heater Tubes A 556/A 556M
Seamless, Cold-Drawn Carbon Steel Tubing for Hydraulic System Service A 822

1.2 One or more of Sections 4.3, 5, 6, 17, 18, 19, 20, 20.1, 22, and 23 apply when the product specification or purchase order has a requirement for the test or analysis described by these sections.

1.3 In case of conflict between a requirement of the product specification and a requirement of this general requirement specification only the requirement of the product specification need be satisfied.

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation (SI) of the product specification is specified in the order.

More ASTM standard pdf

ASTM D3516-89(2011)

ASTM D3516-89(2011)

Standard Test Methods for Ashing Cellulose

$30.00 $60.00

ASTM C1781/C1781M-14a

ASTM C1781/C1781M-14a

Standard Test Method for Surface Infiltration Rate of Permeable Unit Pavement Systems

$29.00 $58.00

ASTM D50-90(2011)

ASTM D50-90(2011)

Standard Test Methods for Chemical Analysis of Yellow, Orange, Red, and Brown Pigments Containing Iron and Manganese

$30.00 $60.00

ASTM C925-79(2000)

ASTM C925-79(2000)

Standard Test Method for Precision Electroformed Wet Sieve Analysis of Nonplastic Ceramic Powders

$26.00 $52.00