Your shopping cart is empty!
ASTM International, 10/01/2004
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:01/10/2004
Pages:6
File Size:1 file , 49 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers four grades of bolting materials with ten classes of yield strength ranging from 50 to 120 ksi [345 to 827 MPa] for use in high-temperature service such as fasteners for pressure vessel and valve flanges. The material requires special processing and is not intended for general purpose applications. The term "bolting material," as used in this specification, covers rolled, forged, or hot-extruded bars; bolts, nuts, screws, washers, studs, and stud bolts. Headed bolts and rolled threads may be supplied.
Note 1 - Other bolting materials are covered by Specification A 193/A 193M and Specification A 437/A 437M.
1.2 Supplementary Requirement S 1 of an optional nature is provided. This shall apply only when specified by the purchaser in the order.
1.3 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished to inch-pound units.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Standard Practice for Measuring Cost Risk of Buildings and Building Systems
$31.00 $62.00
Standard Test Method for Density (Unit Weight), Yield, and Air Content (Gravimetric) of Concrete
$30.00 $60.00
Standard Test Method for Vinyl and Trans Unsaturation in Polyethylene by Infrared Spectrophotometry
$25.00 $50.00
Standard Test Methods for Characterizing Duplex Grain Sizes
$32.00 $65.00