• ASTM A453/A453M-12

ASTM A453/A453M-12

Standard Specification for High-Temperature Bolting, with Expansion Coefficients Comparable to Austenitic Stainless Steels

ASTM International, 05/01/2012

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/05/2012

Pages:7

File Size:1 file , 98 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers five grades of bolting with twelve classes of yield strength ranging from 50 to 120 ksi [345 to 827 MPa] for use in high-temperature service such as fasteners for pressure vessel and valve flanges. See Specification A962/A962M for the definition of bolting. The material requires special processing and is not intended for general purpose applications.

1.2 The following referenced general requirements are indispensable for application of this specification: Specification A962/A962M.

1.3 Supplementary Requirements are provided for use at the option of the purchaser. The Supplementary Requirements shall only apply when specified individually by the purchaser in the purchase order or contract.

1.4 This specification is expressed in both inch-pound units and in SI units; however, unless the purchase order or contract specifies the applicable "M" specification designation (SI units), the inch-pound units shall apply.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

More ASTM standard pdf

ASTM C1354/C1354M-15

ASTM C1354/C1354M-15

Standard Test Method for Strength of Individual Stone Anchorages in Dimension Stone

$32.00 $64.00

ASTM C1063-16b

ASTM C1063-16b

Standard Specification for Installation of Lathing and Furring to Receive Interior and Exterior Portland Cement-Based Plaster

$32.00 $65.00

ASTM F2135-01(2017)e1

ASTM F2135-01(2017)e1

Standard Specification for Molded Drain, Waste, and Vent (DWV) Short-Pattern Plastic Fittings

$32.00 $64.00

ASTM D2199-03(2021)

ASTM D2199-03(2021)

Standard Test Method for Measurement of Plasticizer Migration From Vinyl Fabrics to Lacquers

$23.00 $46.00