• ASTM A480/A480M-06a

ASTM A480/A480M-06a

Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip

ASTM International, 06/15/2006

Publisher: ASTM

File Format: PDF

$43.00$86.00


Published:15/06/2006

Pages:24

File Size:1 file , 210 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers a group of general requirements that, unless otherwise specified in the purchase order or in an individual specification, shall apply to rolled steel plate, sheet, and strip, under each of the following specifications issued by ASTM: Specifications A 167, A 176, A 240/A 240M, A 263, A 264, A 265, A 666, A 693, A 793, and A 895.

1.2 In the case of conflict between a requirement of a product specification and a requirement of this specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this specification and a more stringent requirement of the purchase order, the purchase order shall prevail. The purchase order requirements shall not take precedence if they, in any way, violate the requirements of the product specification or this specification; for example, by waiving a test requirement or by making a test requirement less stringent.

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets, except that when A 480M is specified, shall apply for the dimensional tolerances and not the bracketed SI values in . The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.4 This specification and the applicable material specifications are expressed in both inch-pound and SI units. However, unless the order specifies the applicable "M" specification designation [SI units], the material shall be furnished in inch-pound units.

More ASTM standard pdf

ASTM D2513-06a

ASTM D2513-06a

Standard Specification for Thermoplastic Gas Pressure Pipe, Tubing, and Fittings

$43.00 $86.00

ASTM D5810-96(2006)

ASTM D5810-96(2006)

Standard Guide for Spiking into Aqueous Samples

$30.00 $60.00

ASTM Volume 11.04:2012

ASTM Volume 11.04:2012

ASTM Book of Standards Volume 11.04: Water and Environmental Technology: Waste Management

$109.00 $218.52

ASTM D5739-06

ASTM D5739-06

Standard Practice for Oil Spill Source Identification by Gas Chromatography and Positive Ion Electron Impact Low Resolution Mass Spectrometry

$33.00 $67.00