• ASTM A488/A488M-99

ASTM A488/A488M-99

Standard Practice for Steel Castings, Welding, Qualifications of Procedures and Personnel

ASTM International, 01/01/1999

Publisher: ASTM

File Format: PDF

$32.00$65.00


Published:01/01/1999

Pages:18

File Size:1 file , 250 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice establishes the qualification of procedures, welders, and operators for the fabrication and repair of steel castings by electric arc welding.

1.1.1 Qualifications of a procedure and either or both the operator or welder under Section IX of the ASME Boiler and Pressure Vessel Code shall automatically qualify the procedure and either or both the operator or welder under this practice. P-number designations in the ASME grouping of base metals for qualification may be different than the category numbers listed inTable 1. Refer to Appendix X1 for a comparison of ASTM category numbers with the corresponding ASME P-Number designations.

1.2 Each manufacturer or contractor is responsible for the welding done by his organization and shall conduct the tests required to qualify his welding procedures, welders, and operators.

1.3 Each manufacturer or contractor shall maintain a record of welding procedure qualification tests (Fig. 1), welder or operator performance qualification tests (Fig. 2), and welding procedure specification (Fig. 3), which shall be made available to the purchaser's representative on request.

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this practice.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D6559-22

ASTM D6559-22

Standard Test Method for Determination of Thermogravimetric (TGA) Air Reactivity of Baked Carbon Anodes and Cathode Blocks

$27.00 $54.00

ASTM A507-10

ASTM A507-10

Standard Specification for Drawing Alloy Steel, Sheet and Strip, Hot-Rolled and Cold-Rolled

$26.00 $52.00

ASTM F2167-15

ASTM F2167-15

Standard Consumer Safety Specification for Infant Bouncer Seats

$32.00 $65.00

ASTM D283-84(1999)

ASTM D283-84(1999)

Standard Test Methods for Chemical Analysis of Cuprous Oxide and Copper Pigments (Withdrawn 2008)

$29.00 $58.00