• ASTM A568/A568M-07

ASTM A568/A568M-07

Standard Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for

ASTM International, 09/01/2007

Publisher: ASTM

File Format: PDF

$43.00$86.00


Published:01/09/2007

Pages:29

File Size:1 file , 400 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers the general requirements for steel sheet in coils and cut lengths. It applies to the following specifications that describe carbon steel, structural steel, and high-strength, low-alloy steel (HSLA) furnished as hot-rolled sheet and cold-rolled sheet: Specifications A 414/A 414M, A 424, A 606, A 659/A 659M, A 794, A 1008/A 1008M, A 1011/A 1011M, and A 1039/A 1039M.

1.2 This specification is not applicable to hot-rolled heavy-thickness carbon sheet coils (Specification A 635/A 635M).

1.3 In case of any conflict in requirements, the requirements of the individual material specification shall prevail over those of this general specification.

1.4 For the purposes of determining conformance with this and the appropriate product specification referenced in , values shall be rounded to the nearest unit in the right hand place of figures used in expressing the limiting values in accordance with the rounding method of Practice E 29.

1.5 lists permissible variations in dimensions and mass (see Note 1) in SI [metric] units. The values listed are not exact conversions of the values listed in the inch-pound tables, but instead are rounded or rationalized values. Conformance to is mandatory when the "M" specification is used. Note 1 - The term weight is used when inch-pound units are the standard. However, under SI the preferred term is mass.

1.6 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.7 This specification and the applicable material specifications are expressed in both inch-pound units and SI units. However, unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished to inch-pound units.

More ASTM standard pdf

ASTM E3-01(2007)

ASTM E3-01(2007)

Standard Guide for Preparation of Metallographic Specimens

$33.00 $67.00

ASTM D7372-07

ASTM D7372-07

Standard Guide for Analysis and Interpretation of Proficiency Test Program Results

$25.00 $50.00

ASTM D6906-12a

ASTM D6906-12a

Standard Test Method for Determination of Titanium Treatment Weight on Metal Substrates by Wavelength Dispersive X-Ray Fluorescence

$26.00 $52.00

ASTM E865-12

ASTM E865-12

Standard Specification for Structural Film Adhesives for Honeycomb Sandwich Panels

$27.00 $54.00