Your shopping cart is empty!
ASTM International, 09/10/2003
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:10/09/2003
Pages:3
File Size:1 file , 32 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers killed carbon-manganese-silicon steel plates intended for welded pressure vessels in service at moderate and lower temperatures.
1.2 The maximum thickness of plates supplied under this specification is 1 in. [25 mm].
1.3 For plates produced from coil, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A20/A20M apply.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Standard Guide for Direct-Push Water Sampling for Geoenvironmental Investigations
$33.00 $67.00
Standard Test Method for Tensile-Tear Strength of Bituminuous Roofing Membranes
$27.00 $54.00
Standard Specification for Vinyl Sheet Floor Covering Without Backing
Standard Test Method for Determination of Effect of Moist Heat (50% Relative Humidity and 90 degrees C) on Properties of Paper and Board
$26.00 $52.00