• ASTM A630-03(2009)

ASTM A630-03(2009)

Standard Test Methods for Determination of Tin Coating Weights for Electrolytic Tin Plate

ASTM International, 04/01/2009

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/04/2009

Pages:8

File Size:1 file , 130 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These test methods include four methods for the determination of tin coating weights for electrolytic tin plate as follows:

Test Method
Sections
A-Bendix Test Method
3 to 9
B-Constant-Current, Electrolytic Test Method (Referee Method)
10 to 18
C-Sellar's Test Method
19 to 28
D-Titration Test Method
29 to 37

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

3.1 This test method covers the determination of tin coating weights on steel plate.

10.1 This test method may be used to determine not only the total tin coating weight but also to determine that part of the tin coating which is present as free tin and that part which is present in the alloyed form.

19.1 This test method covers the determination of the total weight of tin carried by a unit area of tinplate.

29.1 This test method is normally applicable to the determination of tin coating weights in the range of 0.50 to 1.50 lb of tin/bb.

Note 4 - For the determination of the coating weights outside of this range, an iodate solution of appropriate concentration should be prepared so that suitable titrant volumes are obtained. For the determination of low tin coating mass in the range from 0.05-0.49 lb/bb, the number of sample specimens should be adjusted appropriately to maintain a minimum total tin mass equivalent to that present on a 0.50 lb/bb specimen. This test method cannot be used to test single spot tin mass for low tin coating material.

More ASTM standard pdf

ASTM G134-95

ASTM G134-95

Standard Test Method for Erosion of Solid Materials by a Cavitating Liquid Jet

$32.00 $65.00

ASTM C1392-00(2014)

ASTM C1392-00(2014)

Standard Guide for Evaluating Failure of Structural Sealant Glazing

$30.00 $60.00

ASTM C986-89(1995)e1

ASTM C986-89(1995)e1

Standard Guide for Developing Training Programs in the Nuclear Fuel Cycle (Withdrawn 2001)

$29.00 $58.00

ASTM F1895-14

ASTM F1895-14

Standard Test Method for Submersion of a Membrane Switch (Withdrawn 2023)

$30.00 $60.00