• ASTM A684/A684M-10a

ASTM A684/A684M-10a

Standard Specification for Steel, Strip, High-Carbon, Cold-Rolled

ASTM International, 10/01/2010

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/10/2010

Pages:10

File Size:1 file , 140 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers cold-rolled, high-carbon strip in coils or cut lengths. Strip is classified as product that is 0.3000 in. [7.6 mm] or less in thickness and over ½ to 2315/16 in. [12.5 to 600 mm] in width, inclusive. Strip tolerance products may be available in widths wider than 2315/16 in. (600 mm) by agreement between purchaser and supplier; however, such products are technically classified as cold-rolled sheet. The maximum of the specified carbon range is over 0.25 to 1.35 %, inclusive. It is furnished in the following types as specified:

1.1.1 Soft spheroidized annealed high-carbon steel is intended for applications requiring maximum cold forming. It is normally produced to give the lowest maximum Rockwell hardness for each grade.

1.1.2 Soft annealed high-carbon steel is intended for applications requiring moderate cold forming. It is produced to a maximum Rockwell hardness.

1.1.3 Intermediate hardness high-carbon steel is intended for applications where cold forming is slight or a stiff, springy product is needed, or both. It is produced to specified Rockwell hardness ranges, the maximum being higher than obtained for the annealed type.

1.1.4 Full hard high-carbon steel is intended for flat applications. It is produced to minimum Rockwell hardness requirements, which vary with grade, microstructure and gauge. Full hard can be produced with either a pearlitic or spheroidized microstructure or a mixture of both. The minimum hardness should be established between the consumer and the producer.

1.2 This specification is applicable for orders in either inch-pound units or SI units.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

More ASTM standard pdf

ASTM C242-21

ASTM C242-21

Standard Terminology of Ceramic Whitewares and Related Products

$30.00 $60.00

ASTM C676-04(2019)

ASTM C676-04(2019)

Standard Test Method for Detergent Resistance of Ceramic Decorations on Glass Tableware

$21.00 $42.00

ASTM D3555-07(2018)

ASTM D3555-07(2018)

Standard Specification for Track-Resistant Black Crosslinked Polyethylene Insulation for Wire and Cable, 90 oC Operation

$26.00 $52.00

ASTM F2080-18

ASTM F2080-18

Standard Specification for Cold-Expansion Fittings with Metal Compression-Sleeves for Crosslinked Polyethylene (PEX) Pipe and SDR9 Polyethylene of Raised Temperature (PE-RT) Pipe

$30.00 $60.00