Your shopping cart is empty!
ASTM International, 03/10/2000
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:10/03/2000
Pages:3
File Size:1 file , 32 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers forged or rolled steel pipe flanges, forged fittings, valves, and parts suitable for use with high-strength transmission-service pipe.
1.2 Several grades of material, based on minimum yield strength requirements, are covered, as indicated in Table 1.
1.3 Supplementary Requirements are provided. Supplementary Requirement S1 is provided for use when purchaser approval is required for repair welding.
1.4 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished to inch-pound units.
1.5 The values stated in either inch-pound units or SI units are to regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Standard Practice for Auditing Amusement Rides and Devices
$28.00 $56.00
Standard Terminology Relating to Clay Products
$30.00 $60.00
Standard Specification for Establishing Operating Limitations and Information for Aeroplanes
$27.00 $54.00
Standard Test Method for Determination of Low Levels of Phosphorus in ILSAC GF 4 and Similar Grade Engine Oils by Inductively Coupled Plasma Atomic Emission Spectrometry
$25.00 $50.00