Your shopping cart is empty!
ASTM International, 10/01/2013
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/10/2013
Pages:2
File Size:1 file , 61 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification2 covers high-strength low-alloy steel plates for service in welded pressure vessels and piping components.
1.2 This material is particularly intended for piping and pressure vessel applications where high strength and improved toughness are required.
1.3 Two grades, designated B and C, are covered by this specification. Grade B provides a minimum yield strength of 50 ksi [345 MPa]. Grade C provides a minimum yield strength of 60 ksi [415 MPa].
1.4 The maximum thickness of plates is limited only by the capacity of the chemical composition and heat treatment to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness to 4 in. [100 mm] for each grade.
1.5 Grade C in the as-rolled condition is sensitive to cracking during flame cutting, transit, and handling, particularly in thicknesses over 2 in. [50 mm]. Plates should not be shipped in the as-rolled condition only except by mutual agreement between the manufacturer and the purchaser.
1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Standard Test Method for Durability of Finish of Zippers to Drycleaning
$28.00 $56.00
Standard Specification for Copper-Beryllium Alloy Rod and Bar
$25.00 $50.00
Standard Guide for Measurement of Remaining Primary Antioxidant Content In In-Service Industrial Lubricating Oils by Linear Sweep Voltammetry
$32.00 $65.00
Standard Specification for Rubber Gaskets for Cast Iron Soil Pipe and Fittings
$26.00 $52.00