Your shopping cart is empty!
ASTM International, 09/15/2015
Publisher: ASTM
File Format: PDF
$45.00$91.00
Published:15/09/2015
Pages:45
File Size:1 file , 800 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers cast iron soil pipe and fittings for use in gravity flow plumbing, drain, waste and vent sanitary, and storm water applications. It establishes standards covering material, manufacture, mechanical and chemical properties, coating, test methods, inspection, certification, product markings, dimensions, and dimensional tolerances for extra heavy and service cast iron soil pipe and fittings. These pipe and fittings are not intended for pressure applications as the selection of the proper size for sanitary drain, waste, vent, and storm drain systems allows free air space for gravity drainage.
1.2 This specification covers pipe and fittings of the following patterns and, when so designated, shall apply to any other patterns that conform with the applicable requirements given in this specification.
1.2.1 Pipe:
Tables
Extra heavy, 21/2 ft (0.75 m), 31/2 ft (1.0 m), 5 ft (1.5 m), 10 ft (3.0 m) lengths
1, 2
Service, 21/2 ft (0.75 m), 31/2 ft (1.0 m), 5 ft (1.5 m), 10 ft (3.0 m)
Outside dimensions (for detailing)
X1.1
1.2.2 Fittings:
1/4 bends; long 1/4 bends
3, 4
1/4 bends, long low-hub
5
1/4 bends, low heel; high heel
6, 7
1/4 bends, short sweep; long sweep
8
1/4 bends, reducing long sweep
9
1/5 bends
10
1/6 bends
1/8 bends; long 1/8 bends
11
1/16 bends
Y branches
12, 13
Y branches, combination 1/8 bends, single
14
Y branches, combination 1/8 bends, double
Sanitary T branches, single
15
Sanitary T branches, double
Sanitary T branches, cleanout
16
Tapped sanitary T branches, single
17
Tapped sanitary T branches, double
T branches, single and double
18
Tapped T branches, single
19
Tapped T branches, double
T branches, cleanout
20
-45° offset fitting
21
Double hubs
22
Long double hubs
Reducers
23
Increasers
24, 25
P traps
Standard Test Methods for Measurement of Energy and Integrated Charge Transfer Due to Partial Discharges (Corona) Using Bridge Techniques
$32.00 $64.00
Standard Test Method for Toluene-Insoluble (TI) Content of Tar and Pitch
$26.00 $52.00
Standard Test Method for Sulfur in Petroleum and Petroleum Products by Energy Dispersive X-ray Fluorescence Spectrometry
$30.00 $60.00
Standard Test Method for Evaluation of the Thermal and Oxidative Stability of Lubricating Oils Used for Manual Transmissions and Final Drive Axles
$33.00 $67.00
