1.1 This specification covers cast iron soil pipe and fittings for use in gravity flow plumbing, drain, waste and vent sanitary, and storm water applications. It establishes standards covering material, manufacture, mechanical and chemical properties, coating, test methods, inspection, certification, product markings, dimensions, and dimensional tolerances for extra heavy and service cast iron soil pipe and fittings. These pipe and fittings are not intended for pressure applications as the selection of the proper size for sanitary drain, waste, vent, and storm drain systems allows free air space for gravity drainage.
1.2 This specification covers pipe and fittings of the following patterns and, when so designated, shall apply to any other patterns that conform with the applicable requirements given in this specification.
1.2.1 Pipe:
|
|
Tables |
|
Extra heavy, 21/2 ft (0.75 m), 31/2 ft (1.0 m), 5 ft (1.5 m), 10 ft (3.0 m) lengths |
1, 2 |
|
Service, 21/2 ft (0.75 m), 31/2 ft (1.0 m), 5 ft (1.5 m), 10 ft (3.0 m) |
1, 2 |
|
Outside dimensions (for detailing) |
X1.1 |
1.2.2 Fittings:
|
|
Tables |
|
1/4 bends; long 1/4 bends |
3, 4 |
|
1/4 bends, long low-hub |
5 |
|
1/4 bends, low heel; high heel |
6, 7 |
|
1/4 bends, short sweep; long sweep |
8 |
|
1/4 bends, reducing long sweep |
9 |
|
1/5 bends |
10 |
|
1/6 bends |
10 |
|
1/8 bends; long 1/8 bends |
11 |
|
1/16 bends |
11 |
|
Y branches |
12, 13 |
|
Y branches, combination 1/8 bends, single |
14 |
|
Y branches, combination 1/8 bends, double |
14 |
|
Sanitary T branches, single |
15 |
|
Sanitary T branches, double |
15 |
|
Sanitary T branches, cleanout |
16 |
|
Tapped sanitary T branches, single |
17 |
|
Tapped sanitary T branches, double |
17 |
|
T branches, single and double |
18 |
|
Tapped T branches, single |
19 |
|
Tapped T branches, double |
19 |
|
T branches, cleanout |
20 |
|
-45° offset fitting |
21 |
|
Double hubs |
22 |
|
Long double hubs |
22 |
|
Reducers |
23 |
|
Increasers |
24, 25 |
|
P traps |
 ASTM D4365-13Standard Test Method for Determining Micropore Volume and Zeolite Area of a Catalyst $31.00 $62.00 ASTM D7842/D7842M-12(2016)Standard Test Method for Holding Strength of Tack and Prong Fastener Attached Buttons $31.00 $62.00 ASTM D5670-95(2014)Standard Test Method for Rubber -- Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by Infrared Spectrophotometry $29.00 $58.00 ASTM A407-07(2013)Standard Specification for Steel Wire, Cold-Drawn, for Coiled-Type Springs $26.00 $52.00 |