• ASTM A758/A758M-14

ASTM A758/A758M-14

Standard Specification for Wrought-Carbon Steel Butt-Welding Piping Fittings with Improved Notch Toughness

ASTM International, 10/01/2014

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/10/2014

Pages:5

File Size:1 file , 81 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers wrought-carbon steel butt-welding seamless or welded fittings specially processed to ensure better notch toughness than that to be expected in fittings manufactured to the requirements of Specification A234/A234M.

1.1.1 Included are elbows, caps, tees, reducers, and other type fittings covered by ASME B16.9.

1.1.2 Heat treatment is required for all fittings.

1.1.3 Fittings with mandatory radiographic examination of welds are included.

1.1.4 Supplementary requirements are provided for use when additional testing or examination is desired.

1.1.5 Cast fittings, and fittings formed from all weld metal, are not included.

1.2 Several type of fittings are provided, as follows:


Type

Heat Treatment
Required

Weld Seam
Finish (5.3.2)

Radiography
Required?

 

30

normalize

UW-35

no

31

normalize

UW-35

yes

32

normalize

UW-35 and ground flush

yes

40

normalize and temper

UW-35

no

41

normalize and temper

UW-35

yes

42

normalize and temper

UW-35 and ground flush

yes

50

quench and temper

UW-35

no

51

quench and temper

UW-35

yes

52

quench and temper

UW-35 and ground flush

yes

1.3 It shall be the responsibility of the purchaser to determine whether material meeting the requirements of this specification is satisfactory for the service application.

1.4 This specification is expressed in both inch-pound units and SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

More ASTM standard pdf

ASTM B753-01

ASTM B753-01

Standard Specification for Thermostat Component Alloys

$26.00 $52.00

ASTM D4741-17

ASTM D4741-17

Standard Test Method for Measuring Viscosity at High Temperature and High Shear Rate by Tapered-Plug Viscometer

$29.00 $58.00

ASTM G189-07(2013)

ASTM G189-07(2013)

Standard Guide for Laboratory Simulation of Corrosion Under Insulation

$34.00 $69.00

ASTM D4658-15

ASTM D4658-15

Standard Test Method for Sulfide Ion in Water

$25.00 $50.00