Your shopping cart is empty!
ASTM International, 09/01/2018
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/09/2018
Pages:5
File Size:1 file , 130 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification2 covers the procedures and acceptance standards for the determination of reduction of area using a tension test specimen whose axis is perpendicular to the rolled surfaces of steel plates 1 in. [25 mm] and greater in thickness. The principal purpose of the testing is to provide a measure of the resistance of a steel plate to lamellar tearing. (See Appendix X1.)
1.2 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 This specification is expressed in both inch-pound and SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Gross Calorific Value of Refuse-Derived Fuel by the Bomb Calorimeter (Withdrawn 2004)
$34.00 $68.00
Standard Test Method for Residual Moisture in a Refuse-Derived Fuel Analysis Sample
$26.00 $52.00
Standard Test Methods for Nitrogen in the Analysis Sample of Refuse-Derived Fuel
$30.00 $60.00
Standard Test Method for Short Rod Fracture Toughness of Cemented Carbides