• ASTM A780-01

ASTM A780-01

Standard Practice for Repair of Damaged and Uncoated Areas of Hot-Dip Galvanized Coatings

ASTM International, 04/10/2001

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:10/04/2001

Pages:3

File Size:1 file , 58 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice describes methods which may be used to repair damaged hot-dip galvanized coatings on hardware, structural shapes, and other products fabricated prior to hot-dip galvanizing, and uncoated areas remaining after initial hot-dip galvanizing. The damage may be the result of welding or cutting (flame), in which case the coating will be damaged predominantly by burning. This practice can also be used to repair hot-dip galvanized coatings damaged by excessively rough handling during shipping or erection. Requirements concerning the renovation of uncoated areas remaining after initial hot-dip galvanizing are contained within the applicable material specification.

1.2 This practice describes the use of low melting point zinc alloy repair rods or powders made specifically for this purpose, the use of paints containing zinc dust, and the use of sprayed zinc (metallizing).

1.3 The extent of repair shall be limited to an area mutually agreeable to the contracting parties. Similarly, contracting parties shall agree to the repair method to be used.

1.4 This standard does not purport to address the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

More ASTM standard pdf

ASTM D6886-03(2009)

ASTM D6886-03(2009)

Standard Test Method for Speciation of the Volatile Organic Compounds (VOCs) in Low VOC Content Waterborne Air-Dry Coatings by Gas Chromatograpy

$30.00 $60.00

ASTM D242/D242M-09

ASTM D242/D242M-09

Standard Specification for Mineral Filler For Bituminous Paving Mixtures

$26.00 $52.00

ASTM D2782-02(2008)

ASTM D2782-02(2008)

Standard Test Method for Measurement of Extreme-Pressure Properties of Lubricating Fluids (Timken Method)

$33.00 $67.00

ASTM D4796-88(1998)

ASTM D4796-88(1998)

Standard Test Method for Bond Strength of Thermoplastic Traffic Marking Materials

$25.00 $50.00