Your shopping cart is empty!
ASTM International, 06/01/2018
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/06/2018
Pages:12
File Size:1 file , 290 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers a group of requirements that are mandatory requirements of the following steel casting specifications issued by ASTM. If the product specification specifies different requirements, the product specification shall prevail.
ASTM Designation
Title of Specification
A27/A27M
Steel Castings, Carbon, for General Application
A128/A128M
Steel Castings, Austenitic Manganese
A148/A148M
Steel Castings, High Strength, for Structural Purposes
A297/A297M
Steel Castings, Iron-Chromium and Iron-Chromium-Nickel, Heat Resistant, for General Application
A447/A447M
Steel Castings, Chromium-Nickel-Iron Alloy (25-12 Class), for High-Temperature Service
A494/A494M
Castings, Nickel and Nickel Alloy
A560/A560M
Castings, Chromium-Nickel Alloy
A743/A743M
Castings, Iron-Chromium, Iron-Chromium-Nickel, Corrosion Resistant, for General Application
A744/A744M
Castings, Iron-Chromium-Nickel, Corrosion Resistant, for Severe Service
A747/A747M
Steel Castings, Stainless, Precipitation Hardening
A890/A890M
Castings, Iron-Chromium-Nickel-Molybdenum Corrosion-Resistant, Duplex (Austenitic/Ferritic) for General Application
A915/A915M
Steel Castings, Carbon and Alloy, Chemical Requirements Similar to Standard Wrought Grades
A958/A958M
Steel Castings, Carbon and Alloy, with Tensile Requirements, Chemical Requirements Similiar to Standard Wrought Grades
A1002
Castings, Nickel-Aluminum Ordered Alloy
1.2 This specification also covers a group of supplementary requirements that may be applied to the above specifications as indicated therein. These are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.
1.3 The requirements of the individual material specification and this general specification shall prevail in the sequence named.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Non-Destructive Photoelastic Measurement of Edge and Surface Stresses in Annealed, Heat-Strengthened, and Fully Tempered Flat Glass
$29.00 $58.00
Provisional Standard Specification for Portable Gasoline and Kerosine Spill Resistant Fueling Systems for Consumer Use (Withdrawn 2003)
Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing for General Service
$30.00 $60.00
Standard Test Method for Water-Extractable Chloride in Aggregate (Soxhlet Method)
$26.00 $52.00
