Your shopping cart is empty!
ASTM International, 02/01/2021
Publisher: ASTM
File Format: PDF
$28.00$57.00
Published:01/02/2021
Pages:6
File Size:1 file , 86 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This specification covers two wrought iron-cobalt alloy types for use in magnetic components requiring high permeability at and above 1.5 T (15 kG) or high saturation flux density. The specific alloy types covered are:
Alloy Type
UNS
Nominal Composition
''
1
R30005
49'''% Co, 49'''% Fe, 2'''% V
2
K92650
27'''% Co, 0.50'''% Cr, balance Fe
1.1.1''This specification also covers material supplied by a producer in the form and physical condition suitable for fabrication into parts that will later be given final heat treatment to achieve the desired magnetic characteristics and, where required, mechanical properties. It covers material supplied in form of forging billets, hot-rolled products (that is, bar, plate, and strip), cold-finished bars, and cold-rolled strip.
1.2''This specification does not cover parts produced by casting or by powder metallurgical techniques.
1.3''The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to customary (cgs-emu and inch-pound) units which are provided for information only and are not considered standard.
1.3.1''There are selected values presented in two units, both of which are in acceptable SI units. These are differentiated by the word ''', or,''' as in '''g/cm³, or, (kg/m³).'''
1.4''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Compatibility of Plasticizers in Poly(Vinyl Chloride) Plastics Under Compression
$24.00 $48.00
Standard Test Method for Dimensional Stability of Fabrics to Changes in Humidity and Temperature
$30.00 $60.00
Standard Test Method for Analysis of Titanium and Titanium Alloys by Direct Current Plasma and Inductively Coupled Plasma Atomic Emission Spectrometry (Performance-Based Test Methodology)
Standard Specification for Anchor Bolts, Steel, 36, 55, and 105-ksi Yield Strength
$29.00 $58.00
