• ASTM A815/A815M-04

ASTM A815/A815M-04

Standard Specification for Wrought Ferritic, Ferritic/Austenitic, and Martensitic Stainless Steel Piping Fittings

ASTM International, 05/01/2004

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/05/2004

Pages:7

File Size:1 file , 61 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers two general classes, WP and CR, of wrought ferritic, ferritic/austenitic, and martensitic stainless steel fittings of seamless and welded construction covered by the latest revision of Specification A 960. Fittings differing from these standards may be furnished in accordance with Supplementary Requirement S8.

1.1.1 Class WP fittings are subdivided into four subclasses: Classes WP-S, WP-W, WP-WX, and WP-WU. They are manufactured to the requirements of Specification A 960, and they shall have pressure ratings compatible with 12.2. Class WP-S fittings are those manufactured from seamless product by a seamless method of manufacture (marked with class symbol WP-S); Class WP-W fittings are those which contain welds where the fitting fabrication or construction welds have been radiographed (marked with class symbol WP-W); and Class WP-WX fittings are those which contain welds where all welds have been radiographed (marked with class symbol WP-WX); and Class WP-WU fittings are those which contain welds where all welds have been ultrasonically tested (marked with class symbol WP-WU).

1.1.2 Class CR fittings are those manufactured to the requirements of MSS SP-43, and they shall have pressure ratings compatible with 12.3.

1.2 This specification does not apply to cast fittings.

1.3 Optional supplementary requirements are provided. When desired, one or more of these may be specified in the order.

1.4 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable "M" specification designation [SI units], the material shall be furnished to inch-pound units.

1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

More ASTM standard pdf

ASTM D566-17

ASTM D566-17

Standard Test Method for Dropping Point of Lubricating Grease

$30.00 $60.00

ASTM F2158-08

ASTM F2158-08

Standard Specification for Residential Central-Vacuum Tube and Fittings

$29.00 $58.00

ASTM E1547-09

ASTM E1547-09

Standard Terminology Relating to Industrial and Specialty Chemicals

$29.00 $58.00

ASTM F2115-02b

ASTM F2115-02b

Standard Specification for Motorized Treadmills

$29.00 $58.00