• ASTM A815/A815M-21

ASTM A815/A815M-21

Standard Specification for Wrought Ferritic, Ferritic/Austenitic, and Martensitic Stainless Steel Piping Fittings

ASTM International, 11/01/2021

Publisher: ASTM

File Format: PDF

$34.00$68.00


Published:01/11/2021

Pages:8

File Size:1 file , 110 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''This specification covers two general classes, WP and CR, of wrought ferritic, ferritic/austenitic, and martensitic stainless steel fittings of seamless and welded construction covered by the latest revision of Specification A960/A960M. Fittings differing from these standards may be furnished in accordance with Supplementary Requirement S58 of Specification A960/A960M.

1.1.1''Class WP fittings are subdivided into four subclasses: Classes WP-S, WP-W, WP-WX, and WP-WU. They are manufactured to the requirements of Specification A960/A960M, and they shall have pressure ratings compatible with 13.2. Class WP-S fittings are those manufactured from seamless product by a seamless method of manufacture (marked with class symbol WP-S); Class WP-W fittings are those which contain welds where the fitting fabrication or construction welds have been radiographed (marked with class symbol WP-W); and Class WP-WX fittings are those which contain welds where all welds have been radiographed (marked with class symbol WP-WX); and Class WP-WU fittings are those which contain welds where all welds have been ultrasonically tested (marked with class symbol WP-WU).

1.1.2''Class CR fittings are those manufactured to the requirements of MSS SP-43, and they shall have pressure ratings compatible with 13.3.

1.2''This specification does not apply to cast fittings.

1.3''Optional supplementary requirements are provided. When desired, one or more of these may be specified in the order.

1.4''This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable '''M''' specification designation [SI units], the material shall be furnished to inch-pound units.

1.5''The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F1411-01(2006)

ASTM F1411-01(2006)

Standard Practice for Presenting Selected Information on Vacuum Cleaners for Consumer Use

$25.00 $50.00

ASTM D4990-97a(2005)e1

ASTM D4990-97a(2005)e1

Standard Specification for Coal Tar Glass Felt Used in Roofing and Waterproofing

$26.00 $52.00

ASTM D6621-00(2006)

ASTM D6621-00(2006)

Standard Practice for Performance Testing of Process Analyzers for Aromatic Hydrocarbon Materials

$30.00 $60.00

ASTM F1601-01(2006)

ASTM F1601-01(2006)

Standard Test Method for Motor Life Evaluation of an Electric Motorized Nozzle for Central Vacuum Cleaning Systems

$29.00 $58.00