Your shopping cart is empty!
ASTM International, 11/01/2018
Publisher: ASTM
File Format: PDF
$34.00$68.00
Published:01/11/2018
Pages:5
File Size:1 file , 180 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers castings made of compacted graphite iron, which is described as cast iron with the graphite in compacted (vermiform) shapes and essentially free of flake graphite in the bulk of the casting.
1.2 No precise quantitative relationship can be stated between the properties of iron in the various locations of the same casting and those of a test bar cast from the same iron (see Appendix X1).
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3.1 Exception-The inch-pound units in Figs. 1-3 are standard. SI units are added for information only.
Note 1: The length of the keel block shall be 6 in. (152 mm).
FIG. 3 Mold for Modified Keel Block
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Guide for Evaluation of Nuclear Graphite Surface Area and Porosity by Gas Adsorption Measurements
$26.00 $52.00
Standard Test Method for Potential Expansion of Portland-Cement Mortars Exposed to Sulfate
$25.00 $50.00
Standard Test Method for Analysis of Tin-Based Solder Alloys for Minor and Trace Elements Using Inductively Coupled Plasma Atomic Emission Spectrometry
$24.00 $48.00
Standard Test Method for Bleeding of Concrete
$27.00 $54.00
