Your shopping cart is empty!
ASTM International, 01/01/2000
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/01/2000
Pages:6
File Size:1 file , 33 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers plain and deformed steel wire and plain and deformed steel welded wire fabric with protective epoxy coating. A Class A minimum coating thickness is required for wire and welded wire fabric intended for use as reinforcement in concrete and masonry. A Class B minimum coating thickness is required for wire and welded wire fabric intended for use as reinforcement in earth. A Type 1 coating is a fusion-bonded epoxy coating that has been designed to be sufficiently flexible to allow fabrication of the coated wire or welded wire fabric. A Type 2 coating is a fusion-bonded epoxy coating that has not been designed to be sufficiently flexible to allow fabrication of the coated wire or welded wire fabric.
Note 1--The coating applicator is identified throughout this specification as the manufacturer.
1.2 Other organic coatings may be used provided they meet the requirements of this specification.
1.3 This specification is applicable for orders in either SI units (Specification A884M) or in inch-pound units [Specification A884].
1.4 The values stated in either SI or inch-pound units are to be regarded as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other except as specifically noted in . Combining values from the two systems may result in nonconformance with this specification.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens
$29.00 $58.00
Standard Specification for Spray-Applied Rigid Cellular Polyurethane Thermal Insulation
$26.00 $52.00
Standard Test Methods for Hydrolyzable Chloride Content of Liquid Epoxy Resins
$21.00 $42.00
Standard Test Method for Motor Octane Number of Spark-Ignition Engine Fuel
$47.00 $94.00