Your shopping cart is empty!
ASTM International, 03/10/2001
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:10/03/2001
Pages:6
File Size:1 file , 58 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers plain and deformed steel wire and plain and deformed steel welded wire fabric with protective epoxy coating. A Class A minimum coating thickness is required for wire and welded wire fabric intended for use as reinforcement in concrete and masonry. A Class B minimum coating thickness is required for wire and welded wire fabric intended for use as reinforcement in earth. A Type 1 coating is a fusion-bonded epoxy coating that has been designed to be sufficiently flexible to allow fabrication of the coated wire or welded wire fabric. A Type 2 coating is a fusion-bonded epoxy coating that has not been designed to be sufficiently flexible to allow fabrication of the coated wire or welded wire fabric.
Note 1--The coating applicator is identified throughout this specification as the manufacturer.
1.2 Other organic coatings may be used provided they meet the requirements of this specification.
1.3 This specification is applicable for orders in either SI units (Specification A884M) or in inch-pound units [Specification A884].
1.4 The values stated in either SI or inch-pound units are to be regarded as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other except as specifically noted in . Combining values from the two systems may result in nonconformance with this specification.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Pulse Oximeters (Withdrawn 2005)
$29.00 $58.00
Standard Guide for Oil Spill Dispersant Application Equipment: Single-point Spray Systems
$25.00 $50.00
Standard Test Method for Corrosion Test for Engine Coolants in Glassware
$23.00 $47.00
Standard Test Method for Determining Susceptibility to Stress-Corrosion Cracking of 2XXX and 7XXX Aluminum Alloy Products