1.1 This specification covers a group of cast duplex stainless steels (austenitic/ferritic).
1.2 The duplex stainless steel alloys offer a combination of enhanced mechanical properties and corrosion resistance when properly balanced in composition and properly heat treated. Ferrite levels are not specified, but these alloys will develop a range of approximately 30 to 60 % ferrite with the balance austenite. It is the responsibility of the purchaser to determine which grade shall be furnished depending on design and service conditions, mechanical properties, and corrosion-resistant characteristics.
Note 1: Because of the possibility of precipitation of embrittling phases, the grades included in this specification are not recommended for service at temperatures above 600 °F [315 °C].
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3.1 Within the text, the SI units are shown in brackets.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
More ASTM standard pdf
ASTM F319-09(2014)
Standard Practice for Polarized Light Detection of Flaws in Aerospace Transparency Heating Elements
$26.00 $52.00
ASTM F1423-97(2008)
Standard Practice for Determination of the Quality of Monochrome Images Produced from Non-Impact Personal Computer Printers
$25.00 $50.00
ASTM D2122-16
Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
$32.00 $64.00
ASTM D5106-08
Standard Specification for Steel Slag Aggregates for Bituminous Paving Mixtures
$26.00 $52.00