Your shopping cart is empty!
ASTM International, 03/10/2002
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:10/03/2002
Pages:3
File Size:1 file , 30 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers hot-wrought, special quality microalloyed carbon steel bars intended for use in applications where as-rolled mechanical properties are desired. A typical end use is hydraulic cylinder shafts.
1.2 The bars shall be furnished to chemical composition and mechanical properties as provided herein. Chemical composition is based on standard carbon steel grades modified to include microalloying elements such as columbium (niobium), vanadium, or molybdenum. Four strength classes are available, designated 60, 75, 80, and 100, corresponding to the minimum yield strength in ksi.
1.3 Sections and sizes of bar steels available are covered in Specification A 29/A 29M.
1.4 Supplementary Requirements S1 to S5 are provided for use when additional controls or requirements are desired. These shall apply only when specified on the purchase order.
1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text and tables, SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.6 Unless the order specifies the applicable "M" specification designation, the material shall be furnished to the inch-pound units.
Standard Practice for Tests to Evaluate the Chemical Resistance of Geonets to Liquids
$24.00 $48.00
Standard Test Method for Steady-State Heat Transfer Properties of Pipe Insulation
$38.00 $76.00
Standard Specification for Copper Conductors for Use in Hookup Wire for Electronic Equipment
$26.00 $52.00
Standard Consumer Safety Specification for Non-Full-Size Baby Cribs/Play Yards
$45.00 $91.00