• ASTM A920/A920M-14(2019)

ASTM A920/A920M-14(2019)

Standard Specification for Steel Bars, Microalloy, Hot-Wrought, Special Quality, Mechanical Properties

ASTM International, 09/01/2019

Publisher: ASTM

File Format: PDF

$21.00$42.00


Published:01/09/2019

Pages:3

File Size:1 file , 68 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers hot-wrought, special quality microalloyed carbon steel bars intended for use in applications where as-rolled mechanical properties are desired. A typical end use is hydraulic cylinder shafts.

1.2 The bars shall be furnished to chemical composition and mechanical properties as provided herein. Chemical composition is based on standard carbon steel grades modified to include microalloying elements such as columbium (niobium), vanadium, or molybdenum. Three strength classes are available, designated 75 [520], 80 [550], and 100 [690], corresponding to the minimum yield strength in ksi.

1.3 Sections and sizes of bar steels available are covered in Specification A29/A29M.

1.4 Supplementary Requirements S1 to S5 are provided for use when additional controls or requirements are desired. These shall apply only when specified on the purchase order.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.6 Unless the order specifies the applicable “M” specification designation, the material shall be furnished to the inch-pound units.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D3721-05(2011)

ASTM D3721-05(2011)

Standard Specification for Synthetic Red Iron Oxide Pigment

$26.00 $52.00

ASTM D3588-98

ASTM D3588-98

Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels

$24.00 $49.20

ASTM D2797/D2797M-11a

ASTM D2797/D2797M-11a

Standard Practice for Preparing Coal Samples for Microscopical Analysis by Reflected Light

$30.00 $60.00

ASTM A216/A216M-93(1998)

ASTM A216/A216M-93(1998)

Standard Specification for Steel Castings, Carbon, Suitable for Fusion Welding, for High- Temperature Service

$21.00 $43.20