Your shopping cart is empty!
ASTM International, 11/01/2015
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/11/2015
Pages:9
File Size:1 file , 220 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers a group of requirements that are mandatory for castings produced by the investment casting process to meet the metallurgical requirements of the following steel casting specifications issued by ASTM.
ASTM Designation
Title of Specification
A27/A27M
Steel Castings, Carbon, for General Application
A128/A128M
Steel Castings, Austenitic Manganese
A148/A148M
Steel Castings, High-Strength, for Structural Purposes
A297/A297M
Steel Castings, Iron-Chromium and Iron-Chromium-Nickel, Heat-Resistant, for General Application
A447/A447M
Steel Castings, Chromium-Nickel-Iron Alloy (25-12 Class), for High-Temperature Service
A494/A494M
Castings, Nickel and Nickel Alloy
A560/A560M
Castings, Chromium-Nickel Alloy
A732/A732M
Castings, Investment, Carbon and Low Alloy Steel for General Application, and Cobalt Alloy for High Strength at Elevated Temperatures
A743/A743M
Castings, Iron-Chromium, Iron-Chromium-Nickel, Corrosion-Resistant, for General Application
A744/A744M
Castings, Iron-Chromium-Nickel, Corrosion Resistant, for Severe Service
A747/A747M
Steel Castings, Stainless, Precipitation Hardening
A890/A890M
Castings, Iron-Chromium-Nickel-Molybdenum Corrosion-Resistant, Duplex (Austenitic/Ferritic) for General Application
A915/A915M
Steel Castings, Carbon and Alloy, Chemical Requirements Similar to Standard Wrought Grades
A958
Steel Castings, Carbon and Alloy, with Tensile Requirements, Chemical Requirements Similar to Standard Wrought Grades
A1002
Castings, Nickel-Aluminum Ordered Alloy
1.2 This specification also covers a group of supplementary requirements that may be applied to the above specifications as indicated therein. These are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order.
1.3 When investment castings are ordered, the requirements stated in this specification form an integral part of the material specification. In cases of conflict, the requirements of this specification shall take precedence over the individual material specification requirements.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Standard Specification for Preformed Flexible Elastomeric Cellular Thermal Insulation in Sheet and Tubular Form
$30.00 $60.00
Standard Specification for Solid Wall High Density Polyethylene (HDPE) Conduit Based on Controlled Outside Diameter (OD)
$29.00 $58.00
Standard Specification for Piping Fittings of Wrought Carbon Steel and Alloy Steel for Moderate and High Temperature Service
Standard Test Methods for Solventless Electrical Insulating Varnishes
