• ASTM A960/A960M-10

ASTM A960/A960M-10

Standard Specification for Common Requirements for Wrought Steel Piping Fittings

ASTM International, 11/01/2010

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/11/2010

Pages:9

File Size:1 file , 190 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers a group of common requirements that shall apply to wrought steel piping fittings covered in any of the following individual product specifications or any other ASTM specification that invokes this specification or portions thereof:

Title of Specification ASTM
Designation
Specification for Piping Fittings of Wrought
Carbon Steel and Alloy Steel for Moderate and
Elevated Temperatures
A234/A234M
Specification for Wrought Austenitic Stainless
Steel Piping Fittings
A403/A403M
Specification for Piping Fittings of Wrought Carbon
Steel and Alloy Steel for Low-Temperature Service
A420/A420M
Specification for Butt-Welding, Wrought-Carbon
Steel, Piping Fittings with Improved Notch Toughness
A758/A758M
Specification for As-Welded Wrought Austenitic
Stainless Steel Fittings for General Corrosive
Service at Low and Moderate Temperatures
A774/A774M
Specification for Wrought Ferritic, Ferritic/Austenitic,
and Martensitic Stainless Steel Piping Fittings
A815/A815M
Specification for Heat-Treated Carbon Steel
Fittings for Low-Temperature and Corrosive Service
A858/A858M
Specification for Wrought High-Strength
Low-Alloy Steel Butt-Welded Fittings
A860/A860M

1.2 In case of conflict between a requirement of the individual product specification and a requirement of this general requirement specification, the requirements of the individual product specification shall prevail over those of this specification.

1.3 By mutual agreement between the purchaser and the supplier, additional requirements may be specified (See 4.1.8). The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon by the purchaser and supplier.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text and the tables, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification. The inch-pound units shall apply unless the "M" designation [SI] of the product specification is specified in the order.

More ASTM standard pdf

ASTM D7224-08

ASTM D7224-08

Standard Test Method for Determining Water Separation Characteristics of Kerosine-Type Aviation Turbine Fuels Containing Additives by Portable Separometer

$33.00 $67.00

ASTM D1370-00

ASTM D1370-00

Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)

$21.00 $42.00

ASTM E1659-00

ASTM E1659-00

Standard Test Methods Coating Weight and Chemical Analysis of Zinc-Nickel Alloy Electrolytically Coated on Steel Sheet

$29.00 $58.00

ASTM C506M-10

ASTM C506M-10

Standard Specification for Reinforced Concrete Arch Culvert, Storm Drain, and Sewer Pipe (Metric)

$30.00 $60.00