Your shopping cart is empty!
ASTM International, 12/01/2016
Publisher: ASTM
File Format: PDF
$31.00$62.00
Published:01/12/2016
Pages:9
File Size:1 file , 120 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers a group of common requirements that shall apply to steel flanges, forged fittings, valves, and parts for piping applications under any of the following individual product specifications:
Title of Specification
ASTM Designation
Forgings, Carbon Steel, for Piping Components
A105/A105M
Forgings, Carbon Steel, for General-Purpose Piping
A181/A181M
Forged or Rolled Alloy-Steel Pipe Flanges, Forged
A182/A182M
Fittings, and Valves and Parts for High Temperature Service
Forgings, Carbon and Low Alloy Steel, Requiring Notch
A350/A350M
Toughness Testing for Piping Components
Forged or Rolled 8 and 9 % Nickel Alloy
A522/A522M
Steel Flanges, Fittings, Valves, and Parts
for Low-Temperature Service
Forgings, Carbon and Alloy Steel, for Pipe Flanges,
A694/A694M
Fittings, Valves, and Parts for High-Pressure Transmission Service
Flanges, Forged, Carbon and Alloy Steel for Low
A707/A707M
Temperature Service
Forgings, Carbon Steel, for Piping Components with
A727/A727M
Inherent Notch Toughness
Forgings, Titanium-Stabilized Carbon Steel, for
A836/A836M
Glass-Lined Piping and Pressure Vessel Service
1.2 In case of conflict between a requirement of the individual product specification and a requirement of this general requirement specification, the requirements of the individual product specification shall prevail over those of this specification.
1.3 By mutual agreement between the purchaser and the supplier, additional requirements may be specified (see Section 4.1.2). The acceptance of any such additional requirements shall be dependent on negotiations with the supplier and must be included in the order as agreed upon between the purchaser and supplier.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text and the tables, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply, unless the “M” designation (SI) of the product specification is specified in the order.
Standard Test Method for Heat Aging of Asbestos Textiles
$26.00 $52.00
Standard Test Method for Rub Abrasion Mar Resistance of High Gloss Coatings
$27.00 $54.00
Standard Test Method of Assay for Alkaline Protease
Standard Practice for Measuring the Uniformity of Furnace Exposure on Test Specimens
$29.00 $58.00
